Roofing
New roofs, replacements and repairs in asphalt, tile, metal and flat torch-down. We check the roof underneath as well as the covering you can see.

Livermore roofs face months of strong summer sun and Altamont winds, while fine dust builds up in gutters between rains.
What we do
New roofs, replacements and repairs in asphalt, tile, metal and flat torch-down. We check the roof underneath as well as the covering you can see.

We form aluminum and copper gutters at your home to fit each roof edge. If your existing gutters are still sound, we also handle repairs, cleaning and guards to help keep leaves out.

Add daylight to a dark room, replace an old unit or find out why one is leaking. We install VELUX skylights and fit the flashing that keeps rain from getting in around them.

Local conditions
Sunset East ranches, South Livermore estates and Springtown developments share long spells of strong summer sun, but their roof shapes differ. We check exposed ridge caps, vent flashings and the condition of shingles rather than judge the roof by age alone. Heat also affects older fascia and plastic fittings. Attic ventilation belongs in a replacement-roof discussion, along with the covering and metal details. The estimate should explain which worn parts need work and which can remain.
Altamont winds carry dust across roofs through the dry months. Leaves and fruit from oaks, olives and other plantings can settle into that dust inside the gutter. The first rain then moves the deposit toward an outlet, where it may collect and slow drainage. A useful cleaning visit checks the channel bottom and pipe, not only the leaves visible from above. It also allows a closer look at any staining or leaking joints along the eave.
Continuous aluminum runs remove splices along straight sections of the roofline. Corners and downspout connections still need careful fitting, and the supports need to hold through temperature changes and wet weather. We size and place the outlets for the roof area feeding them. The ground-level route matters too, especially beside concrete and foundation edges. If water is collecting there, we look at the discharge rather than assume the gutter above is the only part needing attention. If replacement is being considered, ask for the proposal to distinguish the roof covering from related ventilation, flashing and gutter work. You can then compare the included work between estimates without relying on the material name or the total alone.

Metal moves as temperatures rise and fall. On a long gutter run, the corner joints need to allow for that movement rather than depend on a rigid seal that can pull apart. If the same joint keeps dripping after resealing, ask whether movement or the way the run is supported is contributing. More sealant may leave that cause unchanged.
A sunny roof slope may wear differently from a shaded one. Look for the pattern of curling, cracking or granule loss across the roof rather than judge everything from the section visible out front. The attic ventilation also deserves a check. An inspection should explain whether the damage is limited to an area or points toward a broader replacement.
Free estimate
Tell us what's happening at your property, one step at a time. We'll review your request during business hours and arrange a free inspection.
Sat by appointment · Sun closed
100 Example Road, Brentwood, CA 94513 · office@example-roofing.demo
Your property answers are saved in this browser as you go. About saved answers.
Thanks. We will call during business hours to set up the inspection.
That did not send. Call (925) 555-0100 instead and we will take the details over the phone.